Thanks to VK3ASC for contributing this article.

Mac version of FlDigi with FLRig configuration, via USB cable to connect the IC7100.
FLdigi and FLrig can be downloaded from http://www.w1hkj.com/download.html

FLdigi, under configure> operator> Rig tab, Deselect Hardware PTT, Rigcat, Hamlib if selected and only select Use XML-RPC program.



 

Flrig, under Config> Setup> Transceiver, Select the IC7100 in the transceiver list and select PTT via CAT
Ser. port you select the USB driver. You can download the Mac USB driver from https://www.silabs.com/products/mcu/Pages/USBtoUARTBridgeVCPDrivers.aspx



Select NONE in the PTT Port field.

 
 


IC-7100 settings:

Under Connections

USB MOD Level: 10% (This Article explains why)
DATA OFF MOD: MIC
DATA MOD: USB
 
CI-V
CI-V Baud rate: 19200
CI-V Address: 88h
CI-V Transceive: OFF

Must have USB-D or LSB-D selected on the transceiver operating mode for it transmit your digital transmission.

You should check your RF signal as described in this article.

 

Comments   

0 #1 Allen D Kiddoo 2016-12-11 02:36
Thank you for info. Should save me many hours of tinkering to get up and running. Same setup here ic7100 with mac mini. Will be working on it later today. Nice site, great info- keep it up please.

73

You have no rights to post comments